Patio & paver cleaning in Granite Bay
We ask what it's made of first
Patio paver cleaning in Granite Bay starts with one question: what is the surface made of? Granite Bay's larger custom homes tend to carry a lot of hardscape, and the materials vary just as much as the houses. So before any pressure washing or power washing begins, we do a quick surface assessment and match the PSI, nozzle tips, and detergents to the material. That's how softer surfaces stay safe. We handle:
- Concrete pavers and porcelain pavers, plus stamped and exposed-aggregate concrete
- Brick pavers and older clay brick patios
- Natural stone: travertine, flagstone, slate, and yes, granite, a fitting material for Granite Bay
- Custom pavers, tile patios, and pool decks
Delicate stone gets controlled pressure at a lower setting, and we finish with edge detailing so the whole patio reads even, not striped. Paver patio cleaning done this way protects the joints and the finish, and a clean pool deck also cuts the slip hazard along the shaded edges. We run a cold-water rig; hot water is mostly a commercial thing, and residential hardscape cleaning doesn't need it.
The stains
The marks Granite Bay patios collect
We read the surface, then treat what's there. Stain work is a surface treatment matched to the stain: a pre-treatment with the right detergent and dwell time first, controlled pressure second, and a post-treatment rinse to slow regrowth. On Granite Bay patios that usually means:
- Leaf tannin staining from oak leaf litter and acorns, the brown shadows that show up every fall
- Algae, moss, mildew, and other organic growth in the shaded, damp zones
- Oil stains and grease stains around grills and outdoor kitchens
- Rust stains from furniture, fire features, and irrigation water
- Efflorescence, the white haze that wicks up out of pavers after wet winters
We're upfront: deep rust and old grease may not come 100 percent clean. We do our best and tell you what to expect before we start, not after.
Pavers, sand & sealing
Straight talk on pavers
We clean without blowing out the joint sand, but a straight note so there are no surprises: Cable Pressure Washing and Solar Panel Cleaning doesn't offer polymeric sand, paver re-sanding, paver sealing, or concrete sealing right now. We clean the surface and leave it ready if you plan to seal it. If sealing is on your list, that's actually the right order: a clean, dry surface is exactly what sealer adhesion needs, so a proper wash first is step one no matter who applies the sealer.
The process
How a patio cleaning actually goes
Every patio gets the same five steps, and the order is the point: chemistry first, pressure last, so the surface never takes more force than it needs.
- Surface assessment. Concrete pavers, brick pavers, travertine, flagstone, slate, granite, or porcelain: the material sets the PSI, the nozzle, and the detergent before anything gets wet.
- Pre-treatment. Stains and organic growth get a targeted pre-treatment with the right dwell time, which is what actually breaks them down.
- The wash. Broad areas get an even, consistent clean; delicate stone stays at lower, controlled pressure.
- Edge detailing. Edges, corners, and the shaded strips along walls and planters get finished by hand-guided passes so the patio reads even, not striped.
- Post-treatment and rinse-down. A post-treatment slows regrowth, then everything rinses clean, with your landscaping rinsed and protected on both sides of the job.
Joint sand stays put, and if you plan to seal the surface afterward, it is left ready for that.
Local knowledge
Why Granite Bay patios green up faster
The same mature oak canopy that makes lots from Los Lagos to Wexford and Ashley Woods, and the streets around Granite Bay Golf Club, feel established is exactly what works against the patio underneath it. Shade keeps pavers damp long after sprinklers or rain, and shade is where algae and moss hold on through summer. Irrigation overspray from the landscaping does the same thing along planter edges, and where drainage sends runoff across a low corner of the patio, that corner stays green year-round. Then autumn drops leaf litter and acorns on top, and the tannin staining sets in wherever leaves sit wet.
None of that is a defect in your patio; it's just what large, shaded lots between Douglas Boulevard and Auburn Folsom Road do. A proper clean with a post-treatment holds well, and a yearly pass keeps the growth from ever getting ahead of you.
Outdoor living
Built for backyard entertaining
Granite Bay's outdoor living spaces are often built out well beyond a plain slab: full outdoor kitchens, fire features, covered pavilions, pool decks sized for a crowd, and stone walkways tying it all together. Those areas see food, smoke, sunscreen, and foot traffic all season, which is why the grill zone and the pool deck usually look the worst by the time summer near Folsom Lake winds down.
We clean the whole entertaining footprint in one visit: the patio, the pool deck, the walkways, and the paths between them, each at the pressure its material calls for. The result is the kind of curb appeal you can see from the back fence, and a surface that's actually pleasant to walk barefoot again before the next round of backyard entertaining.
What it costs
Patio cleaning prices in Granite Bay
Patio and paver cleaning in Granite Bay from Cable Pressure Washing and Solar Panel Cleaning runs about $0.40 per square foot with a $150 minimum, and most patios land between $150 and $500. We use upfront pricing from a free estimate, and the first 15 round-trip miles are included. Granite Bay's bigger outdoor footprints can land above the typical range on square footage alone, which is why we confirm the number on-site before any work starts.
| Surface | How it's priced | Typical range |
|---|---|---|
| Patio / paver | per sq ft | ~$0.40/sq ft ($150–$500) |
| Pool deck | per sq ft | $150 min |
| Driveway cleaning | per sq ft | ~$0.25/sq ft |
| Sidewalk cleaning | add-on | +$60–$100 |
Want a ballpark before you call? Run your square footage through our pressure washing cost calculator, then we confirm on-site. Prefer a person? Send the quote request form for a call back. You'll get a same-day reply when you reach out, and most jobs are scheduled within 3 days.
One crew, whole exterior
The rest of your Granite Bay home
Since we're already set up, it's easy to add driveway cleaning in Granite Bay, sidewalk cleaning, house washing, gutter cleaning, or solar panel cleaning and get the whole exterior handled in one visit. That's residential exterior cleaning done by the same two people every time, not a rotating crew, and the bundle discount above applies when you combine two or more surfaces.
Why us
Local, honest, insured
Cable Pressure Washing and Solar Panel Cleaning is a father-and-son team, Wesley and Harrison, based in Rocklin, serving Granite Bay from Los Lagos and Wexford to Ashley Woods and the streets around Granite Bay Golf Club, Douglas Boulevard, and Folsom Lake.
We're insured, with liability coverage. On licensing: California doesn't issue a license for pressure washing, so nobody in this trade is licensed for it, but we carry insurance regardless. Every job comes with a satisfaction guarantee, and if you're not happy with an area, we make it right. We're rated 5.0 on Google; the customer reviews are there to read. Check our Google reviews, and ask for before-and-after photos from our gallery when you reach out. See the full driveway, patio, and sidewalk cleaning hub or everything we do in town on our pressure washing in Granite Bay page.
Common questions